T7Design Brushless Water Pump 19mm (3/4") - 24v

T7Design 24v Water / Coolant Circulation Pump

Extreme operational reliability, compact, leak-proof design and the capability of pumping water, antifreeze or coolants under hostile operating conditions are three of the advantages which distinguish the brushless, seal-less pumps from conventional alternatives.

The pump is well adapted for a wide range of demanding applications and operates without problem over a wide range of temperatures while reliably pumping coolants or water over extended periods of time.

Low friction impeller bearings prolong service life and make it possible for the CM10 to withstand dry running for up to 30 minutes. The permanently lubricated ball bearing motor also contributes to the up to 5000 hour uninterrupted service rating of this high-tech pump.

Supplied with mounting bracket.

These water pumps are normal-priming centrifugal pumps and should be mounted in a manner that ensures that they are always flooded or are primed before being switched on.

The pump should not be run dry, excessive wear will occur during dry running even for a short period of time. Max dry running 30 min.

The motors are made for continuous duty and for voltage fluctuation of +/- 20%. Overvoltage reduces component life.

The pump should not be used for soiled water containing hard particles.

ATTENTION

• The pump can be installed in either a horizontal or vertical position. To avoid air-locks when mounted horizontally, the outlet should be turned in such a way that it is directed upwards or is placed on the upper side of the pump body.